Datalogic (Memor K)

 

On the Datalogic device, go to: Settings, Datalogic Settings, Scanner Settings, Symbology settings.
For each of the following barcode types, tap the name of the barcode, then enable Send checksum

• EAN-13, EAN-8, UPC-A, UPC-E

• When done, go back one screen, scroll to the bottom, and select Commit, then select OK.

If this step is not done, the device will lose these settings when it restarts next.

Walkthrough with screen shots

1. Go to Settings

2. Tap on Datalogic Settings

3. Tap on Scanner Settings

4. Tap on Symbology settings

5. Tap on EAN-13

6. Enable Send checksum

7. Go back one screen

8. Repeat for each of EAN-8, UPC-A and UPC-E

9. Go back to the Scanner Settings screen again, scroll to the bottom, and select Commit

10. Tap OK